• Analog Input, Analog output, Digital Input, Digital output, Temperature, Vibration, Safety Relays, intelligent relays, Serial, Cell load modules for hazardous and safe area
• Suitable for SIL 3 applications according to IEC 61508, IEC 61511.
• Suitable for ESD, F&G, DCS, BMS applications.
• Independent power supply circuits for each channel on most modules.
• Dual channel units are equivalent to two single units because of the absence of common circuitry on most modules.
• Single channel versions available when required, to provide single loop integrity .
• Configuration components are easily accessed by removing the side cover or via connector front panel.
• DIP switch confi gurability for easy fi eld setup.
• LED indicator on for power, signal status and line fault conditions.
• Modules accept DC power supply over a wide range for 24 Vdc (18-30 Vdc) applications.
• Wide operating temp. range: -40 to +60/+70 °C.
• Wide range of digital and analog I/O.
• SIL 3 Safety Relay contacts rated for 4 A or 10 A for direct switching of high loads.
• Three port galvanic isolation to eliminate noise, ground loop problems and to provide Intrinsic Safety without a high integrity safety earth connection.
• Line fault alarm detects open or short circuit of field cables.
• Optional power bus DIN-Rail connector.
• Standard Termination on Board with custom connectors for integration into customized Boards.
• EMC Compatibility to EN61000-6-2, EN61000-6-4, EN61326-1, EN61326-3-1 for safety system.
• Installation in Zone 2 / Division 2.
• Certified for Offshore and Marine applications.
• Ultra slim 2 channels 12 mm wide DIN-Rail and Termination Board mounting modules.
• Power and fault on bus connectors.
• 6 mm per channel means 50% space reduction.
• 3 mm per channel on DI module D5231E